| How to assemble the Boardfisher Rack |
| 2. Place the standard nut one on each side of the fishing box to center and hold the cross-member in place. |
| 3. Place wing nut on the outside of the mount. |
| 1. Place the cross-member through the hole at the bottom of the fishing box |
| How to put the BoardFisher Fishing System on the surfboard. |
| 2. Slide the mount all the way to the wing nut otherwise the mount will bind and not allow it to slide on the cross-member. |
| 3. Slide the mounts down over the nose of the surfboard to the desired location and tighten the wing nuts. |
| 1. Expand the mount to the maximum width. |
| 4. After this procedure is done the rack will be adjusted to the size of the surfboard and can be eaisly removed by slightly loosening the wing nuts and sliding the rack off of the nose. |
| The general method to attach the BoardFisher fishing systems to the surfboard is to slide the rack over the nose of the surfboard and tighten the wing nuts. To do this assemble the rack as shown above and follow the steps below. |
| FAQs |
| Will the mount fit all longboards? |
Yes, the mounts will fit all standard longboards. The mounts are made of a special plastic compound that
allows it to expand and conform to the thickness and the contour of the rail.
allows it to expand and conform to the thickness and the contour of the rail.
| Will the mounts fit SUPs (stand up paddle boards)? |
Yes, the mounts will fit SUPs with tapered rails at the nose, however,
the exceptions are the extremely large SUPs and SUPs with
extremely boxie rails at the nose. It is not recommended where the
rail is larger than a 1.5" diameter at the taper 1" in from the rail.
An alternative mounting method is available, however, this requires
deck anchors so that tie down straps can be used. We supply a
SUP Paddler Tie Down Kit, this also is part of the Complete SUP
Fishing System.
the exceptions are the extremely large SUPs and SUPs with
extremely boxie rails at the nose. It is not recommended where the
rail is larger than a 1.5" diameter at the taper 1" in from the rail.
An alternative mounting method is available, however, this requires
deck anchors so that tie down straps can be used. We supply a
SUP Paddler Tie Down Kit, this also is part of the Complete SUP
Fishing System.
| Is the cross-member wide enough for a SUP? |
Yes, a 30" cross-member is available for SUPs.
| Will the mounts fit SUPs (stand up paddle boards)? |
| How to remove Tie Down Kit anchors |
To remove:
1. Place a screwdriver into the slot and twist in a clockwise motion.
2. To remove the adhesive roll off using your finger or rag.
note: the anchors cannot be reused.
1. Place a screwdriver into the slot and twist in a clockwise motion.
2. To remove the adhesive roll off using your finger or rag.
note: the anchors cannot be reused.